Another tea light holder

Home › Forums › Woodturning Gallery › Another tea light holder

This topic contains 2 replies, has 3 voices, and was last updated by brodylee brodylee 4 years, 10 months ago.

  • Author
    Posts
  • December 5, 2014 at 2:40 pm #3827
    Avatar
    Mark
    Participant
    • Skype Name:

    [caption id="" align="alignnone" width="689"] another tea light holder[/caption]

     

    This is an off-cut  of  a piece of Eucalyptus i was given some time ago, it has been a bit difficult to dry but it has been worth the trouble as it turned and finished well and is to be part of the centre piece on the Christmas dinner table.

    Dia –  85mm, Height – 35mm, finished with sanding sealer then two coats of carbunarra  wax. Checking filled with ca glue

    Regards Mark.

     

     

  • December 5, 2014 at 3:19 pm #3828
    ed (the amateur) turner
    ed (the amateur) turner
    Keymaster
    • Skype Name:

    Well done Mark these look good and worthy of the Christmas table 🙂

     

    Ed

  • December 7, 2014 at 11:46 am #3835
    brodylee
    brodylee
    Participant
    • Skype Name:

    Nice one Mark. That’s a good looking offcut! Cracking shape and finish too!

    BBrody

  • Author
    Posts

You must be logged in to reply to this topic.